Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
Sequence numbers for this filter are automatically assigned starting at sequence number 5.
If you do not use the ge or le options, only packets with an exact match to the prefix are filtered.
ip prefix-list
Enter the PREFIX-LIST mode and configure a prefix list.
Syntax
ip prefix-list prefix-name
To delete a prefix list, use the no ip prefix-list prefix-name command.
Parameters
prefix-name Enter a string up to 16 characters long as the name of the prefix list, up to 140
characters long.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
Prefix lists redistribute OSPF and RIP routes meeting specific criteria.
Related
Commands
show ip route list — displays IP routes in an IP prefix list.
show ip prefix-list summary — displays a summary of the configured prefix lists.
230 Access Control Lists (ACL)