Service Manual

● range = inclusive range of ports (you must specify two ports for the port
parameter)
port port Enter the application layer port number. Enter two port numbers if you are using
the range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
● 23 = Telnet
● 20 and 21 = FTP
● 25 = SMTP
● 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keyword dscp.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for non-contiguous mask and added the monitor option.
Deprecated the keyword established.
6.5.10 Expanded to include the optional QoS order priority for the ACL entry.
Access Control Lists (ACL) 209