Service Manual

Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
any Enter the keyword any to specify that all routes are subject to the filter. You can
enter any of the following keywords to specify route types.
● bytes — Enter the keyword count to count packets the filter processes.
● count — Enter the keyword bytesorder to count bytes the filter processes.
● dscp — Enter the keyword dcsp followed by the DCSP value to match to the
IP DCSCP values. The range is from 0 to 63.
● fragments — Enter the keyword fragments to use ACLs to control packet
fragments.
● order — Enter the keyword order to specify the QoS order of priority for
the ACL entry. The range is from 0 to 254 (0 is the highest priority and 254 is
the lowest; lower-order numbers have a higher priority). The default is, if you do
not use the keyword order, the ACLs have the lowest order by default (255).
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address
only.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to
the Quality of Service chapter of the Dell Networking OS Configuration Guide.
The software cannot count both packets and bytes, so when you enter the count byte options, only
bytes increment.
Related
Commands
ip access-list standard — configures a standard ACL.
Access Control Lists (ACL) 193