Service Manual

vrf vrf-name (OPTIONAL) Enter the name of a VRF instance to clear the counters of all IPv6
VRRP groups in the specified VRF. Maximum 32 characters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Added support to clear the interface configurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for
IPv6 VRRP groups in nondefault VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
NOTE: This command also enables you to clear the port configurations corresponding to a range of
ports. However, for Open Networking (ON) platforms the notation for specifying port range in the
command is different from how you specify in non-ON platforms.
● For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you
want to clear the port configurations corresponding to all ports between 1 and 4, specify the port
range as clear counters interfaces interface-type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to clear the port configurations corresponding to all ports
between 1 and 4, specify the port range as clear counters interfaces interface-
type 1/1/1 - 1/1/4.
debug vrrp ipv6
Enable VRRP debugging.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
interface Enter the following keywords and slot/port[/subport] or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
Virtual Router Redundancy Protocol (VRRP) 1541