Service Manual

interface type (OPTIONAL) Enter the following keywords and slot/port[/subport] or number
information:
● For Port Channel interface types, enter the keywords port-channel then the
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
ipv6 (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active
VRRP groups corresponding to that VRF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The following describes the show vrrp brief command shown in the following example.
Item Description
Interface Lists the interface type, slot, and port of the configured VRRP group.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface. If you configured the track
command to track that interface and you disable the interface, the cost is
subtracted from the priority value assigned to the interface.
Pre States whether preempt is enabled on the interface.
● Y = Preempt is enabled.
● N = Preempt is not enabled.
State Displays the operational state of the interface using one of the following:
● NA/IF (the interface is not available).
Virtual Router Redundancy Protocol (VRRP) 1533