Service Manual

If you set the priority command to 255 and the virtual-address is not equal to the interface’s
primary IP address, an error message appears.
show config
View the nondefault VRRP configuration.
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all the VRRP group
configuration information, including default information.
Command Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-if-vrid-4)#show config
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP
group.
Syntax
show vrrp [vrrp-id][brief][interface type][ipv6][interface type][vrf vrf-
name]
Parameters
vrrp-id (OPTIONAL) Enter the virtual router identifier for the VRRP group to view only
that group. The range is from 1 to 255.
brief (OPTIONAL) Enter the keyword brief to view a table of information about the
VRRP groups.
1532 Virtual Router Redundancy Protocol (VRRP)