Service Manual

database Enter the keyword database to enable debugging of configuration changes.
interface Enter the following keywords and slot/port or number information:
● For Port Channel interface types, enter the keywords port-channel then the
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
interface Enter the keyword interface to enable debugging of interface state changes.
ipv6 Enter the keyword ipv6 to enable debugging for IPv6.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
If you do not specify an option, debug is active on all interfaces and all VRRP groups.
description
Configure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, use the no description command.
Parameters
text Enter a text string up to 80 characters long.
Defaults Not enabled.
Command Modes VRRP
1528 Virtual Router Redundancy Protocol (VRRP)