Service Manual

peer-routing
Enable Layer 3 (L3) VLT peer-routing. This command is applicable for both IPv6 and IPv4 interfaces.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults Disabled.
Command Modes VLT DOMAIN (conf-vlt-domain)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
peer-routing-timeout
Configure the delay after which peer routing disables when the peer is unavailable. This command is applicable for both IPv6 and
IPv4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value (in seconds). The range is from 1 to 65535. The default
value is infinity.
Command Modes VLT DOMAIN (conf-vlt-domain)
Default Infinity
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Added support for default value on the S-Series and Z-Series.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Virtual Link Trunking (VLT) 1501