Service Manual

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
This command enables the device to transmit its VLT peer MAC address along with its own MAC address
to the remote VLT domain. By default, a node sends only its own MAC address to the remote VLT
domain.
This configuration is applicable only for an LLDP proxy gateway. A typical use example is a square VLT
topology with single link connecting to the remote peers.
Example
Dell(conf-vlt-domain-proxy-gw-lldp)# vlt-peer-mac transmit
show vlt-proxy-gateway
Displays the VLT proxy gateway configuration.
S4048–ON
Syntax
show vlt-proxy-gateway [info] {lldp | static}
Parameters
lldp Enter the keyword lldp to display details about the LLDP VLT proxy gateway
configuration.
static Enter the keyword static to display details about the static VLT proxy gateway
configuration.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
The proxy-gateway feature may go operationally down for any of the following reasons:
● LLDP is globally disabled.
● LDP is disabled per port.
● VLT port-channel is down.
● LLDP neighbor is down.
If any of these conditions is true, the proxy-gateway feature could be operationally down. If so, it is
shown in the show command output.
VLT Proxy Gateway 1493