Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1491

Example

Dell(conf)#vlt-domain 1

Dell(conf-vlt-domain)#proxy-gateway lldp

Dell(conf-vlt-domain-proxy-gw-lldp)#peer-domain-link port-channel 20

exclude-vlan 3

proxy-gateway peer-timeout

Enables the VLT node to timeout the transmission of the peer MAC address when the VLT peer is down.

S4048–ON

Syntax

[no] peer-timeout value

Parameters

value

Enter the timeout value (in seconds). The range is from 1 to 65535. The default is

infinity.

Default Infinity

Command Modes VLT DOMAIN PROXY GW LLDP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Removed the default value on the S-Series and Z-Series.

9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL Switch.

Usage

Information

When a VLT peer goes down, the local VLT node stops sending its peer’s MAC address. If you configure

this timeout, the local VLT node sends its peer's MAC address until the timer expires.

Use this timer when you enable vlt-peer-mac transmit. A typical use example is a square VLT

topology with a single link connecting to the remote peers.

Example

Dell(conf-vlt-domain-proxy-gw-lldp)# peer-timeout 5

vlt-peer-mac transmit

Enables the device to transmit the peer MAC address along with its own MAC address in LLDP TLV packets to the remote VLT

domain.