Service Manual

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
traceroute
View a packet’s path to a specific device.
Syntax
traceroute {host | vrf instance | ip-address | ipv6-address}
Parameters
host Enter the name of device.
vrf instance (Optional) E-Series Only: Enter the keyword vrf then the VRF Instance name.
ip-address Enter the IP address of the device in dotted decimal format.
ipv6-address Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing
connectivity.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Defaults
● Timeout = 5 seconds
● Probe count = 3
● 30 hops max
● 40 byte packet size
● UDP port = 33434
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale with IPv6.
8.1.1.0 Introduced on the E-Series ExaScale (IPv4 only).
7.9.1.0 Introduced VRF.
7.6.1.0 Added support for the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for IPv6 address on the E-Series.
Control and Monitoring 147