Service Manual

ntp master <stratum>
Configure the switch as NTP Server.
Syntax
ntp master <stratum>
Parameters
ntp
master <stratum>
Enter the stratum number to identify the NTP Server's hierarchy.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.6(0.0) Introduced on the S4810, S4820T, S5000, S6000, Z9000, and Z9500.
9.2(1.0) Introduced on the Z9500.
ntp server
Configure an NTP time-serving host.
Syntax
ntp server[vrf vrf-name] {hostname | ipv4-address | ipv6-address} [key
keyid] [prefer] [version number]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to configure a
NTP time-serving host corresponding to that VRF.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of NTP server.
hostname Enter the hostname of the server.
key keyid (OPTIONAL) Enter the keyword key and a number as the NTP peer key. The range
is from 1 to 4294967295.
prefer (OPTIONAL) Enter the keyword prefer to indicate that this peer has priority over
other servers.
version number (OPTIONAL) Enter the keyword version and a number to correspond to the NTP
version used on the server. The range is from 1 to 4.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
1444 System Time and Date