Service Manual

Command
History
Version Description
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000,
S6000–ON, Z9500, MXL.
Usage
Information
You are guided through a series of queries to configure SupportAssist. The generated commands are
added to the running configuration, including the DNS resolve commands, if configured.
This command starts the configuration wizard for the SupportAssist. At any time, you can exit by entering
Ctrl-C. If necessary, you can skip some data entry.
support-assist activity
Trigger an activity event immediately.
Syntax
support-assist activity {full-transfer} start now
Parameters
full-transfer Enter the keywords full-transfer to specify transfer of configuration,
inventory, logs, and other information.
Command Modes EXEC Privilege
Command
History
Version Description
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000,
S6000–ON, Z9500, MXL.
SupportAssist Commands
Dell Networking OS supports the following SupportAssist mode commands.
activity
Move to the SupportAssist Activity mode for an activity. Allow the user to configure customized details for a specific activity.
Syntax
activity {full-transfer}
To remove all customized detail for a specific activity, use the no activity {activity-name}
command.
Parameters
full-transfer Enter the keywords full-transfer to specify transfer of configuration,
inventory, logs, and other information.
Command Modes SUPPORTASSIST
Command
History
Version Description
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000,
S6000–ON, Z9500, MXL.
Usage
Information
By default, each activity follows a set of default actions using a default schedule. Using this command,
you can customize the set of actions and disable a certain activity.
SupportAssist 1423