Service Manual

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you use the no logging on command, messages are logged only to the console.
Related
Commands
logging — enables logging to the Syslog server.
logging buffered — sets the logging buffered parameters.
logging console — sets the logging console parameters.
logging monitor — sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
1 to 11. The port range is 1.
● For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a Null interface, enter the keyword null then the Null interface number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
Simple Network Management Protocol (SNMP) and Syslog 1377