Service Manual

Parameters
notification-type
Enter the type of notification from the following list:
bgp Notification of changes in the BGP process.
config Notification of changes to the startup or running configuration.
ecfm Notification of changes to ECFM.
ecmp Enable an ECMP trap to notify of ECMP or link bundle traffic
imbalances.
envmon For Dell Networking device notifications when an environmental
threshold is exceeded.
isis Notification of intermediate service traps.
lacp Notification of changes.
snmp Notification of RFC 1157 traps.
stp Notification of a state change in the spanning tree protocol (RFC 1493).
vlt Notification of virtual link trunking.
vrrp Notification of a state change in a VRRP group.
xstp Notification of a state change in MSTP (802.1s), RSTP (802.1w), and
PVST+.
notification-
option
For the envmon notification-type, enter one of the following optional parameters:
cam-utilization
fan
supply
temperature
For the snmp notification-type, enter one of the following optional parameters:
authentication
coldstart
linkdown
linkup
syslog-reachable
syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the following two SNMP notification options: syslog-reachable and
syslog-unreachable.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for copy-config and ECMP traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
1352 Simple Network Management Protocol (SNMP) and Syslog