Service Manual

Example
Dell(conf)# ip access-list standard snmp-ro-acl
Dell(config-std-nacl)#seq 5 permit host 10.10.10.224
Dell(config-std-nacl)#seq 10 deny any count
!
Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related
Commands
ip access-list standard — names (or selects) a standard access list to filter based on IP address.
ipv6 access-list — configures an access list based on IPv6 addresses or protocols.
show running-config — displays the current SNMP configuration and defaults.
snmp-server contact
Configure contact information for troubleshooting this SNMP node.
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type]
[notification-option] command.
Simple Network Management Protocol (SNMP) and Syslog 1351