Service Manual

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
Dell Networking OS enhances the sflow implementation for real time traffic analysis on the E-Series to
provide extended gateway information in cases where the destination IP addresses are learned by
different routing protocols and for cases where the destination is reachable over ECMP.
Related
Commands
show sflow — displays the sFlow configuration.
sflow max-header-size extended
Set the maximum header size of a packet to 256 bytes.
Syntax
sflow max-header-size extended
To reset the maximum header size of a packet, use the[no] sflow max-header-size extended
command.
Parameters
extended Enter the keyword extended to copy 256 bytes from the sample packets to
sFlow datagram.
Defaults 128 bytes
Command Modes
CONFIGURATION
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S Series and Z Series switches.
Example
Dell(conf)#sflow max-header-size extended
sFlow 1339