Service Manual

Version Description
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
The source-interface interface attribute is applicable for both the SSH client as well as the
COPY (SCP) commands. Using these attributes the client session tags an error to the user during run
time, in case there is a mismatch between this command and the ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 1/42
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
ip ssh vrf
Specify a VRF for an outgoing SSH connections.
Syntax
ip ssh vrf vrf-name
To delete a VRF for an outgoing SSH connection, use the no ip ssh vrf vrf-name command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to configure that VRF for an
outgoing SSH session.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
If you configure a VRF for an SSH session, then you need not explicitly mention the same VRF for the
SSH client sessions intended for that VRF. The vrf attribute in the ip ssh vrf command is applicable
for both the SSH client as well as the COPY (SCP) commands.
Example
Dell(conf)#ip ssh vrf vrf1
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh vrf vrf1
show crypto
Display the public part of the SSH host-keys.
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell Networking representative.
Security 1311