Service Manual

● enable: use the password the enable password command defines in
CONFIGURATION mode.
● line: use the password the password command defines in LINE mode.
● none: no authentication.
● radius: use the RADIUS servers configured with the radius-server host
command.
● tacacs+: use the TACACS+ server(s) configured with the tacacs-server
host command.
... method2 (OPTIONAL) In the event of a “no response” from the first method, Dell
Networking OS applies the next configured method.
Defaults Use the enable password.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Usage
Information
By default, the Enable password is used. If you configure aaa authentication enable
default, Dell Networking OS uses the methods defined for Enable access instead.
Methods configured with the aaa authentication enable command are evaluated in the order
they are configured. If authentication fails using the primary method, Dell Networking OS employs the
second method (or third method, if necessary) automatically. For example, if the TACACS+ server is
reachable, but the server key is invalid, Dell Networking OS proceeds to the next authentication method.
The TACACS+ is incorrect, but the user is still authenticated by the secondary method.
Related
Commands
enable password — changes the password for the enable command.
login authentication — enables AAA login authentication on the terminal lines.
password — creates a password.
radius-server host — specifies a RADIUS server host.
tacacs-server host — specifies a TACACS+ server host.
Security 1259