Service Manual

Related
Commands
qos dscp-color-map — configures the DSCP color map
qos dscp-color-policy— configures a DSCP color policy
qos dscp-color-map
Configure the DSCP color map.
Syntax
qos dscp-color-map map-name
To remove a color map, use the no qos dscp-color-map map-name command.
Parameters
map-name Enter the name of the DSCP color map. The map name can have a maximum of 32
characters.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.7(0.0) Introduced on the S6000-ON.
9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information
A color map outlines the codepoint mappings to the appropriate color mapping (green, yellow, red) for the
traffic. The system uses this information use to handle the traffic on the interface based on the traffic
priority and places it into the appropriate shaping queue. You cannot delete a DSCP color map when it is
configured on an interface. If you do, all the DSCP values are set to green (low drop precedence). To
delete the DSCP color map that is being used by one or more interfaces, remove the DSCP map from
each interface.
Example
Dell(conf)#qos dscp-color-map mymap
Related
Commands
qos dscp-color-map— associates the DSCP color map profile with an interface so that all IP packets
received on it is given a color based on that color map
dscp— sets the number of specific DSCP values for color map profile to yellow or red.
qos dscp-color-policy
Associates the DSCP color map profile with an interface so that all IP packets received on it is given a color based on that color
map.
Syntax
dscp-color-policy color-map-profile-name
To remove a color policy map profile, use the no dscp-color-policy color-map-profile-name
command.
Parameters
color-map-
profile-name
Enter the color map profile name. The name can have a maximum of 32 characters.
Defaults None
Command Modes CONFIG-INTERFACE
1192 Quality of Service (QoS)