Service Manual

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
To assign drop precedence to green or yellow traffic, use this command. If there is no honoring enabled
on the input, all the traffic defaults to green drop precedence.
Related
Commands
wred-profile — creates a WRED profile and name that profile.
trust — defines the dynamic classification to trust DSCP.
wred ecn
To indicate network congestion, rather than dropping packets, use explicit congestion notification (ECN).
S4048–ON
Syntax
wred ecn
To stop marking packets, use the no wred ecn command.
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-out)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820t.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
When you enable wred ecn, and the number of packets in the queue is below the minimum threshold,
packets are transmitted per the usual WRED treatment.
When you enable wred ecn, and the number of packets in the queue is between the minimum threshold
and the maximum threshold, one of the following two scenarios can occur:
Quality of Service (QoS) 1189