Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Expanded to add support for Layer 2.
6.1.1.1 Introduced on the E-Series.
Usage
Information
You can attach a single policy-map to one or more interfaces to specify the service-policy for those
interfaces. A policy map attached to an interface can be modified.
NOTE: The service-policy commands are not allowed on a port channel. The service-
policy input policy-map-name command and the service-class dynamic dot1p
command are not allowed simultaneously on an interface. However, the service-policy input command
(without the policy-map-name option) and the service-class dynamic dot1p command are allowed on
an interface.
Related
Commands
policy-map-input — creates an input policy map.
service-policy output
Apply an output policy map to the selected interface.
S4048–ON
Syntax
service-policy output policy-map-name
To remove the output policy map from the interface, use the no service-policy output
policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
You can identify an existing policy map or name one that does not yet exist.
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Quality of Service (QoS) 1173