Service Manual

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
The default burst size is 100Kb. If a different value is required, you must configure the burst size to the
required value.
Related
Commands
rate police — specifies traffic policing on the selected interface.
qos-policy-input — creates a QoS output policy.
rate-shape
Shape traffic output as part of the designated policy.
S4048–ON
Syntax
rate-shape [kbps | pps] peak-rate [burst-kbps | burst-packets] commited
[kbps | pps] commited-rate [burst-kbps | burst-packets]
Parameters
pps Enter the keyword pps to specify the rate limit in packets per second (pps).
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps).
Make the following value a multiple of 64. The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
burst-kbps (OPTIONAL) Enter the burst size in KB. The range is from 0 to 40000. The default
is 100.
burst-packets Enter the peak rate or committed rate burst size in packets per seconds.
Defaults Burst size is 10KB. Granularity for rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-OUT
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Quality of Service (QoS) 1171