Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1161

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

7.4.1.0 and

6.5.3.0

Introduced on the E-Series.

Usage

Information

This command does not uniquely identify a queue, but rather identifies only a set of queues. The WRED

Curve is applied to all eight ingress Multicast queues.

NOTE: The multicast-bandwidth option is not supported on queue ingress. If you attempt to

use the multicast-bandwidth option, the following reject error message is generated: %

Error:Bandwidth-percent is not allowed for ingress multicast.

rate-police

Specify the policing functionality on incoming traffic.

S4048–ON

Syntax

rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-

KB]]

Parameters

kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps).

Make the following value a multiple of 64. The range is from 0 to 40000000. The

default granularity is Megabits per second (Mbps).

committed-rate

Enter the bandwidth in Mbps. The range is from 0 to 40000.

burst-KB

(OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The

default is 100.

peak

peak-rate

(OPTIONAL) Enter the keyword peak then a number to specify the peak rate in

Mbps. The range is from 0 to 40000. The default is the same as designated for

committed-rate.

Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity for

committed-rate and peak-rate is Mbps unless you use the kbps option.

Command Modes QOS-POLICY-IN