Service Manual

policy-map-output
Create an output policy map.
S4048–ON
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the C-Series and S-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables
Policy-Map-Output Configuration mode (conf-policy-map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
S4048–ON
Syntax
qos-policy-input qos-policy-name cpu-qos | layer2
To remove an existing input QoS policy from the router, use the no qos-policy-input qos-
policy-name cpu-qos | layer2 command.
Parameters
qos-policy-name Enter the name for the policy map in character format (32 characters maximum).
1166 Quality of Service (QoS)