Service Manual

Usage
Information
To access this command, enter the class-map command. You can match against only one VLAN ID.
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map
(output) applied on an interface.
S4048–ON
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name
command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
An aggregate output QoS policy applies to all outbound port traffic. An aggregate output QoS policy can
coexist with per-queue output QoS policies. If the rate shape exists in both aggregate and per-queue qos-
policy, minimum of 2 take effect. Some of all Queue-rate will not exceed aggregate.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
1164 Quality of Service (QoS)