Service Manual

Example
(Address)
Dell#show ip pim rp 229.1.2.1
Group RP
229.1.2.1 165.87.20.4
show ip pim snooping interface
Display information on VLAN interfaces with PIM-SM snooping enabled.
Syntax
show ip pim snooping interface [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about a specified VLAN
configured for PIM-SM snooping. The valid VLAN IDs range is from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series ExaScale.
Usage
Information
The following describes the show ip pim snooping interface commands shown in the following
example.
Field Description
Interface Displays the VLAN interfaces with PIM-SM snooping enabled.
Ver/Mode Displays the PIM version number for each VLAN interface with PIM-SM snooping
enabled:
● v2 = PIM version 2
● S = PIM Sparse mode
Nbr Count Displays the number of neighbors learned through PIM-SM snooping on the
interface.
DR Prio Displays the Designated Router priority value configured on the interface (ip pim
dr-priority command).
DR Displays the IP address of the Designated Router for that interface.
Example (#2)
Dell#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
1112 PIM-Sparse Mode (PIM-SM)