Service Manual

Policy-based Routing (PBR)
Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR, create a redirect list and
apply it to the interface. After the redirect list is applied to the interface, all traffic passing through the interface is subject to
the rules defined in the redirect list. PBR is supported by the Dell Networking Operating System (OS).
You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area
network [VLAN]). Trace lists and redirect lists do not function correctly when you configure both in the same configuration.
NOTE: Apply PBR to Layer 3 interfaces only.
NOTE: For more information , refer to Content Addressable Memory (CAM) chapter.
Topics:
• description
• ip redirect-group
• ip redirect-list
• permit
• redirect
• seq
• show cam pbr
• show ip redirect-list
description
Add a description to this redirect list.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the IP redirect list (16 characters maximum).
Defaults none
Command Modes REDIRECT-LIST
Command
History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
Related
Commands
ip redirect-list – enables an IP Redirect List.
41
Policy-based Routing (PBR) 1085