Service Manual

Command Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
You can configure an arbitrary value in the IP address for each router. However, each router ID must be
unique.
If this command is used on an OSPFv3 process that is already active (has neighbors), all the neighbor
adjacencies are brought down immediately and new sessions are initiated with the new router ID.
Related
Commands
clear ipv6 ospf process – resets an OSPFv3 router process.
show crypto ipsec policy
Display the configuration of IPsec authentication and encryption policies.
Syntax
show crypto ipsec policy [name name]
Parameters
name name (OPTIONAL) Displays configuration details about a specified policy.
Defaults No default behavior or values.
Command Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.0 Introduced on the E-Series TeraScale.
8.3.19.0 Introduced on the S4820T.
Usage
Information
The show crypto ipsec policy command output displays the AH and ESP parameters configured
in IPsec security policies, including the SPI number, keys, and algorithms used.
1076 Open Shortest Path First (OSPFv2 and OSPFv3)