Service Manual

Version Description
8.4.2.0 Introduced on the E-Series TeraScale.
8.3.19.0 Introduced on the S4820T.
Usage
Information
Before you enable IPsec encryption on an OSPFv3 interface, first enable OSPFv3 globally on the router.
Configure the same encryption policy (same SPI and keys) on each interface in an OSPFv3 link.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the router.
When you configure encryption for an OSPFv3 area with the area encryption command, you enable
both IPsec encryption and authentication. However, when you enable authentication on an area with the
area authentication command, you do not enable encryption at the same time.
If you have enabled IPsec authentication in an OSPFv3 area with the area authentication
command, you cannot use the area encryption command in the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over an area-level
configuration. If you remove an interface configuration, an area encryption policy that has been
configured is applied to the interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number
command.
Related
Commands
ipv6 ospf encryption – configures an IPsec encryption policy on an OSPFv3 interface.
show crypto ipsec policy – display the configuration of IPsec encryption policies.
auto-cost
Specify how the OSPF interface cost is calculated based on the reference bandwidth method.
S4048–ON
Syntax
auto-cost [reference-bandwidth ref-bw]
To return to the default bandwidth or to assign cost based on the interface type, use the no auto-
cost [reference-bandwidth ref-bw] command.
Parameters
ref-bw (OPTIONAL) Specify a reference bandwidth in megabits per second. The range is
from 1 to 4294967. The default is 100 megabits per second.
Defaults 100 megabits per second.
Command Modes ROUTER OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the S6000-ON, S6000, S4820T, S4810, S5000, Z9500, S3048-ON,
and S4048-ON
Usage
Information
Example
Dell#show running-config ospf
!
ipv6 router ospf 10
log-adjacency-changes
Open Shortest Path First (OSPFv2 and OSPFv3) 1059