Service Manual

No-Buffer 0 Seq-No 0 Socket 0
Q-OverFlow 0 Unkown-Pkt 0
Error packets (Only for TX)
Socket Errors 0
Dell#
Usage
Information
The show ip ospf process-id statistics command displays the error packet count received
on each interface as:
● The hello-timer remaining value for each interface
● The wait-timer remaining value for each interface
● The grace-timer remaining value for each interface
● The packet count received and transmitted for each neighbor
● Dead timer remaining value for each neighbor
● Transmit timer remaining value for each neighbor
● The LSU Q length and its highest mark for each neighbor
● The LSR Q length and its highest mark for each neighbor
Example
(Statistics)
Dell(conf-if-te-1/6)#do show ip ospf statistics
Interface TenGigabitEthernet 1/6
Error packets (Receive statistics)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unknown-Pkt 0 Bad-LsReq 0
RtidZero 0
Neighbor ID 4.4.4.4
Packet Statistics
Hello DDiscr LSReq LSUpd LSAck
RX 5 2 1 3 2
TX 6 5 1 3 3
Timers
Hello 0 Wait 0 Grace 0
Dead 39 Transmit 4
Queue Statistics
LSU-Q-Len 0 LSU-Q-Wmark 1
LSR-Q-Len 0 LSR-Q-Wmark 1
Dell(conf-if-te-1/6)#
Related
Commands
clear ip ospf statistics — clears the packet statistics in all interfaces and neighbors.
show ip ospf timers rate-limit
Show the LSA currently in the queue waiting for timers to expire.
Syntax
show ip ospf [process-id] timers rate-limit
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3) 1051