Service Manual

ip telnet server enable
Enable the Telnet server on the switch.
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
ip ssh server — enables the secure shell (SSH) server on the system.
ip telnet server vrf
Configures the TELNET server on either a specific VRF or a management VRF.
Syntax
ip telnet server vrf {management | vrf-name}
To undo the TELNET server configuration, use the no ip telnet server [vrf vrf-name]
command.
Parameters
vrf management Enter the keyword vrf followed by the keyword management to specify a
management VRF that is used by the TELNET server.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify the VRF that is
used by the TELNET server.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Control and Monitoring 103