Administrator Guide

removed
DellEMC#
Related
Commands
• reload – reboots Dell EMC Networking OS.
show redundancy
Display the current redundancy configuration (status of automatic reboot configuration on stack management unit).
Syntax
show redundancy
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information To modify your results, use the show redundancy [pipe] command, as follows:
• except — show only text that doesn not match a pattern.
• find — search for the first occurrence of a pattern.
• grep — show only text that matches a pattern.
• no-more — do not paginate the output.
• save — save the output to a file.
Example
DellEMC#show redundancy
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 1
Stack-unit ID: 1
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: 1-0(0-4812)
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer Stack-unit ID: 2
Stack-unit SW Version: 1-0(0-4812)
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 1
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
Stacking 1559