Users Guide

13 Dell EMC Networking ONIE Quick Start Guide
Diag Version 0x2E 10 3.33.3.1-6
CRC-32 0xFE 4 0x474D58A6
Checksum is valid.
INSTALLER DONE...
Removing /tmp/tmp.bSyRpb
ONIE: NOS install successful: tftp://100.67.2.65/diag-installer-x86_64-
dellemc_s4100_c2338-r0-3.33.3.1-6-2018-02-05.bin
ONIE: Rebooting...
5.2 Firmware Updates
To update the firmware, BIOS/CPLD perform the following steps:
1. Boot the switch into ONIE: Rescue mode.
Note: The install package must be first downloaded from support.dell.com and accessible via http/tftp/ftp.
2. Enter the following command to install the package:
onie-self-update tftp://<ip address>/onie-firmware-x86_64-
dellemc_s4100_c2338-r0.3.33.5.1-19.bin
Verify that installation was successful. See the Diagnostics section to resolve any issues encountered with
the firmware update or with the individual components.