Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

881

882

883

884

885

886

887

888

889

890

Table Of Contents

rx Enter the keyword rx to set the mode to receive.

Defaults Both transmit and receive.

Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series.

Commands

● protocol lldp (Configuration) — enable LLDP globally.

● show lldp neighbors — display the LLDP neighbors.

multiplier

Set the multiple of the hello timer before LLDP declares the interface dead.

Syntax

multiplier number

To return to the default, use the no multiplier command.

Parameters

integer

Enter the number of consecutive misses before the LLDP declares the interface

dead. The range is from 2 to 10.

Defaults 4