Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

Table Of Contents

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.0(0.0) Added support for IPv6 for the file-url parameter.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Added support for TFTP and SCP.

7.6.1.0 Introduced on the S-Series.

Usage

Information

RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must be enclosed in

square brackets, [X:X:X:X::X]. For maximum flexibility this command accepts IPv6 host addresses with or

without the square brackets.

Reload Dell Networking OS after executing this command. To copy Dell Networking OS from the

management unit to one or more stack members, use the upgrade system stack-unit (S-

Series stack member) command.

Example

Dell# upgrade system ?

ftp: Copy from remote file system (ftp://userid:password@hostip/

filepath)

scp: Copy from remote file system (scp://userid:password@hostip/

filepath)

tftp: Copy from remote file system (tftp://hostip/filepath)

Dell# upgrade system ftp://username:password@10.11.1.1/FTOS-SB-7.7.1.0.bin

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!

Erasing Sseries ImageUpgrade Table of Contents, please wait

.!........................................................

...........................................................

....................................!

12946259 bytes successfully copied

Dell# reload

Dell#

upgrade system

Upgrade the Dell Networking OS image. To upgrade the bootflash or bootselector image, use the upgrade boot command.

Syntax

upgrade system {flash: | ftp: | nfsmount: | scp: | stack-unit {stack-unit-

id | all} | tftp: | usbflash:} file-url {A: |B:}

Parameters

system Enter the keyword system to upgrade the operating system (OS) image.

flash:

file-url

Enter the keyword flash: and specify the location of the image file in the

format //directory-path or press Enter to launch a prompt sequence.

ftp:

file-url

Enter the keyword ftp: and specify the location of the image file in the format //

userid:password@host-ip/filepath or press Enter to launch a prompt

sequence.

File Management 77