Service Manual

configured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default configurations only.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series E600i.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEther
net 1/1...
Displays the interface’s type, physical and line protocol status.
Internet
address...
States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the configured incoming access list. If none is configured, the
phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface.
ICMP redirects... States if ICMP redirects are sent.
ICMP
unreachables...
States if ICMP unreachable messages are sent.
Example
Dell# show ip int te 1/1
TenGigabitEthernet 1/1 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
IPv4 Routing 733