Service Manual

Parameters
minutes Enter the number of minutes. The range is from 0 to 35790. The default is 240
minutes.
Defaults 240 minutes (4 hours)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related
Commands
● show interfaces — display the ARP timeout value for all available interfaces.
clear arp-cache
Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries from the content
addressable memory (CAM).
Syntax
clear arp-cache [vrf vrf-name | interface | ip ip-address] [no-refresh]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to clear the
ARP cache corresponding to that VRF.
interface (OPTIONAL) Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
ip ip-address (OPTIONAL) Enter the keyword ip then the IP address of the ARP entry you wish
to clear.
IPv4 Routing 693