Service Manual

Version Description
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Example
Dell# show interfaces status
Port Description Status Speed Duplex Vlan
Te 1/1 Up 1000 Mbit Auto --
Te 1/2 Down Auto Auto 1
Te 1/3 Down Auto Auto 1
Te 1/4 Down Auto Auto --
Te 1/5 DellPort Up 1000 Mbit Auto 30-130
Te 1/6 Down Auto Auto --
Te 1/7 Down Auto Auto --
Te 1/8 Up 1000 Mbit Auto 1502,1504,1506-1508,1602
Te 1/9 Down Auto Auto --
Te 1/10 Down Auto Auto --
Te 1/11 Down Auto Auto --
Te 1/12 Down Auto Auto --
Te 1/13 Down Auto Auto --
Te 1/14 Down Auto Auto --
Te 1/15 Down Auto Auto --
Te 1/16 Down Auto Auto -
Dell#
Related
Commands
● show interfaces — display information on a specific physical interface or virtual interface.
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q
tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to a
range of ports.
● For physical interfaces, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-
type 1/1 - 4.
● For port–channel interfaces, you can specify multiple ports as port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces port—
channel 1 - 4.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack member number.
Command Modes
● EXEC
● EXEC Privilege
Interfaces 647