Service Manual

● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
● Up at 1000 Mb/s
● Up at 100 Mb/s
● Up at 100 Mb/s
● Down
● Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
monitor interface
Monitor counters on a single interface or all interfaces. The screen is refreshed every five seconds and the CLI prompt
disappears.
Syntax
monitor interface [interface]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
● For the Management interface on the stack-unit, enter the keyword
managementEthernet then the slot/port information.
● For a port channel interface, enter the keyword port-channel and then a
number.
● For a Tunnel interface, enter the keyword tunnel then the slot/port. The
range is from 1 to 16383.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
628 Interfaces