Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
Usage
Information
When you insert or remove a secondary RPM with logical SFM, the system must add or remove the
backplane links to the switch fabric trunk. To avoid traffic disruption, use this command when you
insert the secondary RPM. When you execute this command, the logical SFM on the standby RPM is
immediately taken offline and the SFM state is set as “standby”.
NOTE: This command could affect traffic when taking the secondary SFM offline.
Example
Dell# show sfm all
Switch Fabric State: up
-- Switch Fabric Modules --
Slot Status
--------------------------------------
0 active
1 active
Dell# configure
Dell(conf)# redundancy sfm standby
Taking secondary SFM offline...
!
Dell(conf)# do show sfm all
Switch Fabric State: up
-- Switch Fabric Modules --
Slot Status
-----------------------------------------
0 active
1 standby
Dell(conf)# no redundancy sfm
Taking secondary SFM online...
!
10Dell(conf)# do show sfm all
Switch Fabric State: up
-- Switch Fabric Modules --
Slot Status
-------------------------------------------
0 active
1 active
redundancy synchronize
Manually synchronize data once between the Master and Stand-by stack units.
Syntax
redundancy synchronize [full]
Parameters
full Enter the keyword full to synchronize all data.
Default Not configured.
Command Modes EXEC Privilege
High Availability (HA) 577