Service Manual

Example (1)
Dell# show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : TenGigabitEthernet 1/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
Dell#
Example (2
Summary)
Dell# show frrp 2 summary
Dell#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Dell#
Related
Commands
● protocol frrp — enter the resilient ring protocol and designate a ring identification.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-
interval milliseconds} command.
Parameters
hello-interval
milliseconds
Enter the keyword hello-interval then the time, in milliseconds, to set
the hello interval of the control packets. The milliseconds must be entered in
increments of 50 millisecond; for example, 50, 100, 150, and so on. If an invalid
value is entered, an error message is generated. The range is from 50 to 2000 ms.
Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in milliseconds, to set the dead
interval of the control packets. The range is from 50 to 6000 ms. Default: 1500
ms.
NOTE: The configured dead interval must be at least three times the hello
interval.
Defaults
● 500 ms for hello-interval milliseconds
● 1500 ms for dead-intervalmilliseconds
Command Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
558 Force10 Resilient Ring Protocol (FRRP)