Service Manual

Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
All the default catch-all entries in the longest prefix match (LPM) table collect and transmit all unresolved
IPv6 packets to the CPU, even if they are destined for unknown destinations.
show cpu-queue rate cp
Display the rates for each CPU queue.
Syntax
show cpu-queue rate cp
Defaults Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies the service-policy based on the type of protocol defined in the ACL rules.
Create ACL and QoS policies prior to enabling this command.
Example
Dell#show cpu-queue rate cp
Service-Queue Rate (PPS) Burst (Packets)
-------------- ----------- ----------
Q0 600 512
Q1 1000 50
Q2 300 50
Q3 1300 50
Q4 2000 50
Q5 400 50
Q6 400 50
Q7 400 50
Q8 600 50
Q9 600 50
Q10 600 50
Control Plane Policing (CoPP) 419