Service Manual

Usage
Information
This command applies the service-policy based on the type of protocol defined in the ACL rules.
Create ACL and QoS policies prior to enabling this command.
For CoPP, use the keyword cpu-qos when creating qos-policy-input.
Related
Commands
● ip access-list extended — creates an extended IP ACL.
● mac access-list extended — creates an extended MAC ACL.
● qos-policy-input — creates a QoS input policy map.
● class-map — creates a QoS class map.
● policy-map-input — creates an input policy map.
ip unknown-unicast
Enable IPv4 catch-all route.
Syntax
ip unknown-unicast [vrf vrf-name]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding table in hardware which
gets added as a default configuration after the initialization of FIB Agent module, use the no ip
unknown-unicast command.
Defaults None
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to enable
catch-all routes corresponding to that VRF.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S–Series.
Usage
Information
Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route forwarding table if it was
deleted using the no ip unknown-unicast command previously. This will be the default configuration
after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
418 Control Plane Policing (CoPP)