Service Manual

A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications received from
neighbors.
out (OPTIONAL) Enter the keyword out to view BGP notifications sent to neighbors
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added ipv6 support.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp command.
debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group-name] soft-
reconfiguration
To disable, use the debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-
group-name] soft-reconfiguration command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable
soft-reconfiguration debugging on that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers
within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
334 Border Gateway Protocol