Service Manual

dei mark
Set the DEI value on egress according to the color currently assigned to the packet.
S4048–ON
Syntax
dei mark {green | yellow} {0 | 1}
Parameters
0 | 1 Enter the bit value you want to map to a color.
green | red |
yellow
Choose a color:
● Green: High priority packets that are the least preferred to be dropped.
● Yellow: Lower priority packets that are treated as best-effort.
Defaults All the packets on egress are marked with DEI 0.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Enable DEI before using this command.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in
its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
interface Enter the following keywords and the interface information:
● For a Port Channel interface, enter the keywords port-channel, and then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
Defaults Not configured.
VLAN Stacking 1459