Service Manual

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
● logging — enables logging to a Syslog server
● logging on — enables logging.
logging history
Specify which messages are logged to the history table of the switch and the SNMP network management station (if
configured).
Syntax
logging history level
To return to the default values, use the no logging history command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 4 or warnings.
Defaults warnings or 4
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you configure the snmp-server trap-source command, the system messages logged to the
history table are also sent to the SNMP network management station.
Related
Commands
● show logging — displays information logged to the history buffer.
Simple Network Management Protocol (SNMP) and Syslog 1357