Service Manual

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the name of a sub-tree
or a MIB. The following Example configures a view named rview that allows access to all objects under
1.3.6.1.
Example
Dell# conf
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related
Commands
● show running-config snmp — displays the SNMP running configuration.
snmp-server vrf
Configures an SNMP agent to bind to a specific VRF.
Syntax
snmp-server vrf vrf-name
To undo the SNMP agent configuration, use the no snmp-server vrf vrf-name command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to associate an SNMP agent
with that VRF.
Defaults Not Enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes the requests from the
interfaces that belong to the specified VRF. If no VRF is specified, then the default VRF is used.
Related
Commands
● show snmp user — display the information configured on each SNMP user name.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
Simple Network Management Protocol (SNMP) and Syslog 1347