Service Manual

Version Description
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type]
[notification-option] command.
Parameters
notification-type Enter the type of notification from the following list:
● bgp — Notification of changes in the BGP process.
● config — Notification of changes to the startup or running configuration.
● ecfm — Notification of changes to ECFM.
● ecmp — Enable an ECMP trap to notify of ECMP or link bundle traffic
imbalances.
● envmon — For Dell Networking device notifications when an environmental
threshold is exceeded.
● isis — Notification of intermediate service traps.
● lacp — Notification of changes.
●
snmp — Notification of RFC 1157 traps.
● stp — Notification of a state change in the spanning tree protocol (RFC 1493).
● vlt — Notification of virtual link trunking.
● vrrp — Notification of a state change in a VRRP group.
● xstp — Notification of a state change in MSTP (802.1s), RSTP (802.1w), and
PVST+.
notification-
option
For the envmon notification-type, enter one of the following optional parameters:
● cam-utilization
● fan
● supply
● temperature
For the snmp notification-type, enter one of the following optional parameters:
● authentication
● coldstart
● linkdown
● linkup
● syslog-reachable
● syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
1334 Simple Network Management Protocol (SNMP) and Syslog