Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1081

Table Of Contents

To return to the default value, use the no ip pim [vrf vrf-name] spt-threshold

[infinity] command.

Parameters

value (OPTIONAL) Enter the traffic value in kilobits per second. The default is 10 packets

per second . A value of zero (0) causes a switchover on the first packet.

vrf

vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure

the PIM router on that VRF.

NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.

infinity (OPTIONAL) Enter the keyword infinity to never switch to the source-tree.

Defaults Not configured.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.1) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series.

Usage

Information

This command is applicable to last hop routers on the shared tree towards the rendezvous point (RP).

no ip pim snooping dr-flood

Disable the flooding of multicast packets to the PIM designated router.

Syntax

no ip pim snooping dr-flood

To re-enable the flooding of multicast packets to the PIM designated router, use the ip pim

snooping dr-flood command.

Defaults Enabled.